10
Working in Manual mode:
In manual mode the 892’s self-leveling mechanism is disengaged
so that you can set the laser lines at any slope you require.
1. Remove the laser from the case and place it on a at,
vibraon free surface or tripod.
2. Press manual mode buon. Laser projects crossed lines
without self-leveling.
3. Choose the beams you want to use by pushing the
Beam Selector.
4. Now you can lt the laser as needed to mark the desired
slope. Use the folding legs to adjust the angle and the
height.
5. To turn the laser o, press the Manual buon again.
6. Before moving the laser level be sure to switch to
laser to the OFF posion which engages the lock protect
mechanism.
To Next Page
Loading...
