EasyManua.ls Logo

Ironside PTC Series - Safety Instructions

Ironside PTC Series
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Control panel
Two levels switch with 3 positions, heating level I : 1000Wlevel II : 2000W
Adjustable thermostat, 040 Celsius, 270 degree.
First turn the thermostat to the maximum positionswitch the appliance on
with the biggest power inputwhen the desired room temperature is reached
turn the thermostat anticlockwise till it turns off (a “click ” is heard). The thermostat
then will automatic turn on and off to keep the room temperature constant.
It is normal when odor is blew off from the PTC heating element by the first
use. It will cease to happen when used again.
After the use, follow the below steps to operate the heater: turn off the
thermostat and switch (OFF position), unplug and let the appliance cool down in
the air. When the appliance cools down completely, put it in the packaging. Avoid
to store the unit before the heating element doesn’t cool down, it’s dangerous to
store the hot unit.
4. Safety instructions
Warning: In order to avoid overheating, do not cover the heater.
It is important to read following instructions carefully before using the
appliance
Connect the plug only in an earthed socked with rated voltage.
Children should be supervised to ensure that they do not play with the
appliance. The appliance is not intended for use by person (including children)
with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge. If the appliance is damaged, do not use it any more.
The heating device shall not be installed below a socket-outlets.
Do not use outdoors or in humid place. Never use the heater in the bathroom,
shower or near a swimming pool etc.
Do not place the appliance on moving vehicles or some where easy to be
tipped over.
When you do not use the appliance for a long time, unplug the appliance. Do