EasyManuals Logo

Ironton 170F User Manual

Ironton 170F
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
° °
bove 80 F
more frequently.
Below 40 F
( )
the use of SAE 30 will result in hard startin
g
.
A
(
27 C) the use of 10W-30 may cause increased oil consumption. Check oil level
1.
2.
3.
Move Throttle lever (D) to MIN. position. Turn
Engine switch (F) to the OFF position.
Turn Fuel shutoff (I) to the OFF position.
Troubleshooting
If Engine will not start
Out of fuel
.If engine is cold, ensure choke lever is set correctly. .
Add fuel
Engine flooded
. Set choke lever to open/run position
Dirty or faulty spark plug/engine fails to product spark
Remove spark plug and clean it. Check the spacing on the electrode and set the gap to the .correct
dimension. See Maintenance Section. If plug is damaged, replace with a new spark plug.
. Ensure the spark plug is installed and wire is connected.
Warning:
. Do not crank engine with spark plug removed.
Oil
Oil Recommendations
. We recommend the use of suitable oils for best performance. Other high-quality detergent oils are
acceptable if classified for service SF, SG, SH. SJ or higher.
. Do not use special additives.
. Outdoor temperatures determine the proper oil viscosity for the engine. Use the chart to select the best viscosity
for the outdoor temperature range expected.
Note:
° °
Before adding or checking the oil
· Place engine on a level surface.
· Clean the oil fill area of any debris.
6
4 C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ironton 170F and is the answer not in the manual?

Ironton 170F Specifications

General IconGeneral
BrandIronton
Model170F
CategoryEngine
LanguageEnglish