To Next PageTo Next PageWhy don't the telescoping sections of my Ironton 81869 slide freely?
If the telescoping sections inside your Ironton Racks & Stands are rusted, they may not slide freely. To resolve this, apply paraffin wax or candle wax to the sides as a lubricant.
How to fix casters that don’t swivel smoothly on Ironton Racks & Stands?
If the casters on your Ironton Racks & Stands don’t swivel smoothly, it might be due to rusted caster bearings. Oiling the caster wheel bearings should resolve this issue.
Read and understand all instructions. Failure to follow all instructions may result in serious injury or property damage.
Inspect the work area before each use. Keep work area clean, dry, free of clutter, and well-lit.
To avoid injury, slide bar lock must be fully engaged if winch assembly is extended.
Do not exceed the rated load capacity. Only use the hoist to raise and lower one panel at a time.
Secure load before raising or lowering load. Use ONLY for lifting a drywall panel.
Control the winch with your right hand on wheel handle BEFORE releasing brake. Be sure the winch components are clean and dry.
Lists key subassemblies: Tripod Base, Winch Assembly, Cradle Assembly.
Instructions on setting up the tripod base, including locking casters or using the backstop.
Inspect the unit for wear or damage, especially the cable. Ensure hoist is at working temperature and winch brake drum is clean.
Follow safety warnings, secure load, and control the winch handle before releasing the brake.
Instructions for unlatching and rotating the outer legs for working or storage positions.
Pivot the backstop to prevent rolling or allow free movement.
Always store hoist in a dry, protected area. Completely lower cradle and clean all surfaces.
Inspect hoist before use and after use. Oil caster bearings and pulleys, use wax on telescoping sections.
Addresses casters not swiveling and telescoping sections not sliding freely.
One-year limited warranty against material/workmanship defects. Excludes normal wear, abuse, misuse, and improper maintenance.
Retain receipt, contact customer service for claims, and provide product/receipt for processing.
Sole remedy is replacement/refund. User assumes risk for unintended uses.
Read and understand all instructions. Failure to follow all instructions may result in serious injury or property damage.
Inspect the work area before each use. Keep work area clean, dry, free of clutter, and well-lit.
To avoid injury, slide bar lock must be fully engaged if winch assembly is extended.
Do not exceed the rated load capacity. Only use the hoist to raise and lower one panel at a time.
Secure load before raising or lowering load. Use ONLY for lifting a drywall panel.
Control the winch with your right hand on wheel handle BEFORE releasing brake. Be sure the winch components are clean and dry.
Lists key subassemblies: Tripod Base, Winch Assembly, Cradle Assembly.
Instructions on setting up the tripod base, including locking casters or using the backstop.
Inspect the unit for wear or damage, especially the cable. Ensure hoist is at working temperature and winch brake drum is clean.
Follow safety warnings, secure load, and control the winch handle before releasing the brake.
Instructions for unlatching and rotating the outer legs for working or storage positions.
Pivot the backstop to prevent rolling or allow free movement.
Always store hoist in a dry, protected area. Completely lower cradle and clean all surfaces.
Inspect hoist before use and after use. Oil caster bearings and pulleys, use wax on telescoping sections.
Addresses casters not swiveling and telescoping sections not sliding freely.
One-year limited warranty against material/workmanship defects. Excludes normal wear, abuse, misuse, and improper maintenance.
Retain receipt, contact customer service for claims, and provide product/receipt for processing.
Sole remedy is replacement/refund. User assumes risk for unintended uses.
General| Brand | Ironton |
|---|---|
| Model | 81869 |
| Category | Racks & Stands |
| Language | English |
