Irradiant SSDL-3201RGB

Questions and Answers

M
Matthew MorganJul 31, 2025
What to do if Irradiant SSDL-3201RGB Lighting Equipment fixtures do not work?
- E
  elizabethrobertsAug 1, 2025
  If your Irradiant Lighting Equipment fixtures aren't working, first check if the power source is on and the cord is in good working order. If the issue persists, cut off the power source and replace the fuse with one of the same type. If the fuse burns out repeatedly, there may be a connection problem, and you should consult a qualified technician.
K
kurt33Aug 11, 2025
Why does Irradiant Lighting Equipment reset normally, but the console responds abnormally or not at all?
- J
  jacquelinerobertsAug 11, 2025
  If your Irradiant Lighting Equipment resets normally but the console isn't responding, it could be due to a false or incomplete data connection. Check, repair, or replace the data line, ensuring the connection is secure and the first lamp’s single input is connected to the controller output. Another potential cause is a false address setting, so verify the DMX address. Also, the signal output may not match the pin (pins 2 and 3 having a wrong sequence), in this case toggle the PHASE button on the controller to reverse the polarity.
J
Jose JohnsonAug 21, 2025
How to troubleshoot Irradiant SSDL-3201RGB when it resets normally, but the console has no response?
- P
  pgarciaAug 21, 2025
  If your Irradiant Lighting Equipment resets normally, but the console has no response, consider these steps: 1. Check, repair, or change the data line to fix any false or incomplete data connection, ensuring the first lamp’s input connects to the controller output. 2. Check the DMX address to rule out a false address setting. 3. To identify problems with signal connectors, pull out the signal output and input of one fixture and connect them directly. If it works, the fixture you pulled out has problems. Repeat this process for the remaining fixtures. If any problem persists, please contact a technician.