22
ISETTA
USE AND MAINTENANCE MANUAL
428000372237
EN
Any work conducted on the equipment MUST involve disconnection from the power socket and in any
case, none of the protective elements (grid, casing) should be removed by non-quali! ed staff. The
equipment must absolutely not be operated when these protective elements have been removed.
The person responsible for the equipment is required to have maintenance performed on the
equipment according to the frequency indicated in the table below, contacting the authorised Technical
Assistance when necessary.
9. MAINTENANCE
MAINTENANCE
OPERATION FREQUENCY AUTHORISED
PERSONNEL
Cleaning the external surfaces Depending upon use and necessity User
Cleaning the accessible internal parts
(without the use of tools)
Depending upon use and necessity User
Check power cable,
plugs and/or electric sockets
Monthly / Six-monthly User
Check integrity of sealing gaskets Monthly User
Condenser cleaning Monthly / Six-monthly Technical
assistance
Check the compressor oil level
(if included)
Six-monthly Technical
assistance
Air tank draining
(if included)
Six-monthly Technical
assistance
Check pneumatic connections
(if included)
Six-monthly Technical
assistance
Check integrity of chiller system piping Six-monthly Technical
assistance
Inspect cables and internal power
connections
Six-monthly Technical
assistance
Clean with sponges to dry out condensation
(if included)
Six-monthly Technical
assistance
SPECIAL
OPERATION AUTHORISED
PERSONNEL
Replace lamps / LED
(if included)
Technical
assistance
Replace control panel
(electronic control unit - thermal switch - etc.)
Technical
assistance
Replace power cable,
plugs and/or electric sockets
Technical
assistance
To Next Page
Loading...
