40
GB
Symbols on the machine
See figure 1.
A Forbidden to put fingers underneath the visor when it is folded down.
B Adjusting the stapling power.
C Rating plate with the following data:
Manufacturer.
Type designation of machine.
Serial number.
Electrical data.
Max. number of staples per minute.
Marking for type approval.
CE mark for compliance according to EU Directive (This mark will be
found on machines sold in certain countries).
Year of manufacture.
D The machine complies with the German requirements for radio
interference suppression. (This mark will be found on machines sold in
certain countries).
E The machine has been tested and approved by TÜV. (This mark will be
found on machines sold in certain countries).
F The machine has been tested and approved by UL and CSA. (This mark
will be found on machines sold in certain countries).
DESCRIPTION OF RAPID 101E
The Rapid 101E is an electrically powered table stapler intended for saddle
and flat stapling.
The parts of the machine are shown in figure 2.
G Visor
H Work table
J External paper guide
K Internal paper guide
L Locking handle for work table
M Magazine
N Stapling anvil
O Trigger
P Wheel for adjusting
stapling force
R Switch
S Pedal
T Clamp screw
U Guide plate
The work table can be set in two positions:
Horizontal, for flat stapling
Angled, for saddle stapling.
The machine is operated by pressing down the foot pedal or automatically by
pushing the stapling object into the stapling position. When using the
automatic method the position of the trigger should be adjusted so that the
staples come in the desired position relative to the edge of the stapling
object. Saddle stapling can only be done with the pedal.
To Next Page
Loading...