45
GB
Stapling movement not triggered
- Power supply not turned on.
Check that the machine is connected to the electric socket.
Check that the lamp in the switch is illuminated when the machine is in
operation.
Check that there is voltage at the electric socket (a fuse may have
blown).
- Check that the trigger springs back again when stapling.
- The machine is damaged. Send it away for service.
REPLACING THE INSERT STAPLER
When replacing the insert use one of the guide plates supplied with the
machine and the socket head wrench. Replace the insert as follows. See
figure 9:
1 Position the work table as described in the section “Adjusting the work
table for saddle stapling”.
2 Remove the power supply by pulling out the plug from the electric socket.
3 Move the trigger close to the anvil.
4 Undo the two screws holding the insert using the socket head wrench.
5 Pull the insert out carefully and remove it from the machine, being careful
not to damage the trigger mechanism.
6 Open the magazine on the new insert.
7 Select the guide plate that corresponds to the type of staple shown on
the new insert magazine.
8 Carefully press the guide plate into the discharger on the new insert and
close the magazine.
9 Position the new insert in the machine.
10 Adjust the guide plate in the anvil so that the insert assumes the correct
position.
11 Screw the insert into position using the screws at the same time as the
guide plate is fitted to suit the anvil.
12 Open the magazine and remove the guide plate.
13 Check on the following before switching on the machine:
- That the insert is fitted straight and stable in the machine.
- That the trigger is undamaged and can be adjusted to the desired
position.
- That the magazine can be pressed down against the anvil.
To Next Page
Loading...