MINI PW CONTROLLER
(Power version)
2
The electric towel dryer controller is designed for drying water-washed clothing.
Any other use is prohibited.
Always make sure that the master switch is off before proceeding with
installation or maintenance.
Do not use the towel dryer prior to its proper and complete installation by a
qualified electrician and hot-water heating technician.
Do not switch on the controller until the wiring has been checked and all cables
are connected in accordance with manufacturer instructions. Check the
controller for any damage and the O-ring for proper installation.
Do not turn off the controller by disconnecting the supply cable.
Do not use the controller if the electric circuit is not connected to a circuit
breaker.
If the electrical cord is damaged, have the appliance replaced.
The nominal voltage of the controller must match the nominal voltage of the
supply network (230 V AC ±10%).
The socket outlet (only appliances with a male plug) and power supply must be
compatible with the required performance.
The socket must be compatible with the controller plug (applies to appliances
with a male plug only).
Check to ensure that the power supply system is connected to a socket circuit
breaker.
Class I appliances (a yellow-green conductor or earthing pin) may only be
connected to sockets or terminals with earthed contacts in accordance with
applicable standards.
Prevent any contact of the appliance with chemicals or alcohol, including the
towel dryer liquid.
The appliance should not be operated by children or persons
- with sensory perception disorders or mental health problems
- lacking experience or knowledge necessary for operation of the
appliance (unless under the supervision of a person responsible for their
safety and capable of following the manual instructions).
Prevent unattended children form tampering with the appliance.
Never insert any metal objects, fingers, etc. in the controller connection area.
To Next Page
Loading...
Need help?
General