MINI PW CONTROLLER
(Power version)
7
WARRANTY
1. Seller's warranty applies only to the tightness, surface finish, specified parameters of heating output
and pressure losses of heating units professionally installed in a closed hot water system in
accordance with applicable standards and regulations, including the corrosion properties of the heat
carrying liquid used exclusively as heating medium and never as service water.
2. All heating bodies must be professionally installed in accordance with applicable standards in a
closed hot water system completed in a professional manner under VDI 2035 with respect to
protection against damage caused by corrosion and scale.
3. The corrosive effects of the environment in which the heating units are installed shall not exceed the
surface finish requirements set out in the applicable standard.
4. Electric heating units shall be professionally installed in accordance with applicable standards and
standard regulations regarding appliance location in bathrooms, IPX4 rating – Zone 2, IPX1 rating –
Zone 3. Units with a heating rod must be stored at a temperature above – 5°C.
Warranty periods:
- bathroom pipe radiators, warranty period of 5 years for white and colour radiators, 2 years for
chrome radiators (from delivery to the customer).
- two-year warranty for the electronic controller and the heating rod from the date of sale. All
warranty repairs of electric heating units are to be carried out exclusively at authorized
locations.
The warranty covers only manufacturing and/or material defects which occur during the warranty
period.
The warranty can be claimed against this warranty card and the original purchase document (receipt) issued
by the seller in respect of the product purchased. This document must include an identification of the product,
the date of sale and the retail outlet stamp. Copies and receipts with missing data will not be accepted for
warranty purposes. The warranty can be claimed directly with the seller.
The customer's right to warranty repairs shall be forfeited in the event that the heating units were:
- installed in buildings, at facilities or on premises where higher levels of humidity are a concern;
this applies particularly to public toilets, car wash facilities, animal pens, indoor swimming pools,
etc.;
- stored outdoors exposed to the elements and/or stored at temperatures below – 5°C;
- damaged and their water tightness compromised due to corrosion caused by, for example,
inappropriate chemical composition of the heat-transfer fluid;
- deformed as a result of improper transport or exceeding the maximum operating excess
pressure limit;
- mechanically damaged by the purchaser or in transit;
- unprofessionally installed or their framework was tampered with without approval of the seller;
- used for other than normal purposes, particularly for drying fabrics directly on the towel dryers
without the use of the appropriate accessories, which causes damage to the surface finish;
- any changes made in the warranty card by an unauthorized person;
- failure to complete or loss of the warranty card.
The warranty shall not apply to wear beyond normal wear and tear. If no defect caused by the manufacturer
is detected during the inspection or if warranty conditions are not met, all costs associated with said
inspection and/or repair shall be borne by the purchaser.
All defective units sent by post must be properly wrapped in the original packaging.
To Next Page
Loading...
Need help?
General