iseg SHQ Series - 4 Operation; Front Panel; Picture 2: Front Panel

Spezialelektronik GmbH
iseg Spezialelektronik GmbH Email: sales@iseg-hv.de Phone ++ 49 (0)351 / 26 996 – 0
Bautzner Landstr 23 http://www.iseg-hv.com Fax ++ 49 (0)351 / 26 996 – 21
D - 01454 Radeberg / Rossendorf Germany 9
4 Operation
4.1 Front panel
Picture 2: Front panel
Option IWP: Hardware current limit with 10-turn potentiometer
The upper figure shows the panel for the SHQ module in the standard version with 10 percent switches for voltage and
current limit.
The front panel for modules with option IWP ″Hardware current limit setting with 10-turn potentiometer″ is shown in the lower
figure.
The mains supply (including switch and fuse), a 9-pin female D-Sub connector for the RS 232 interface, the HV-outputs and
the polarity switches are located on the rear side.