the desired Preset button. HD and analog stations can be stored. HD stations are
indicated by HD1, HD2 or HD3 following the station frequency.
• DISP will change the display to show artist or song title if available.
ISGM571 and ISGM572
• The HDRT should be connected to Device2.
• Press the BAND button until is displayed. Turn the rotary TUNE KNOB until is
displayed. Press the FWD>> button to select HD Radio as the source. If you are
currently in the XM mode you will need to press ►ISEEK instead of FWD>>. To
change between HD-FM and HD-AM press the CAT button until HD1, HD2 or HD3
is displayed. Press a button below the displayed text to select that band.
• Tune up - Turn the rotary TUNE KNOB to the right to move up one frequency at
a time.
• Tune down - Turn the rotary TUNE KNOB to the left to move down one
frequency at a time.
• ►ISEEK will seek up to the next available station based on signal strength.
• ◄SEEK will seek down to the next available station based on signal strength.
• Storing stations - Tune to the desired station. Press FWD>> and use the TUNE
knob to select 1-18. PRE 1-18 will be displayed. Press I◄ SEEK to store the station
into memory. To recall a preset station press the FWD>> button and use the TUNE
knob to select a preset 1-18. Press the ►ISEEK button to select the displayed
preset. HD and analog stations can be stored. HD stations are indicated by HD1,
HD2 or HD3 following the station frequency.
• i - will change the display to show artist or song title if available.
ISHD571
• The HDRT should be connected to Device 2.
• Press the XM button and then turn the TUNE KNOB until HD-FM is displayed.
Press PRESET 6 to select the source. By pressing the XM button after HD-FM has
been selected you will switch between HD-FM or HD-AM.
• Tune up - turn the rotary TUNE KNOB clockwise to move up one frequency at a
time.
• Tune down - turn the rotary TUNE KNOB counter-clockwise to move down one
frequency at a time.
To Next Page
Loading...
