To Next PageTo Next PageWhy is there noise/static with my iSimple IS77?
Noise or static may occur due to a few reasons. First, ensure that you are tuned to the frequency specified on the side of the iSimple IS77 interface. Also, a local radio station might be interfering with the auxiliary input device; try changing the frequency setting on the side of the IS77 to the other position and use the new frequency to access the audio source.
What to do if there is no audio from the Aux source on my iSimple IS77 Automobile Electronics?
If you're not getting any audio from the Aux source, there could be a few reasons. First, make sure the iSimple IS77 is turned on by moving the rocker switch to the ON position. Also, check all connection cables to ensure they are properly connected. Lastly, verify that the FM radio is tuned to the frequency on the side of the interface.
Why is the audio so low on my iSimple IS77 Automobile Electronics?
Low audio can occur for a couple of reasons. First, check that the volume is turned up on the audio source to ensure the best sound quality through the iSimple IS77. If the volume is already up on the source, try adjusting the gain setting on the back side of the IS77.
What to do if my iPod does not charge with iSimple IS77 Automobile Electronics?
If your iPod isn't charging, first ensure the power connection on the iSimple IS77 is properly connected. If the connection is good, the fuse in the power plug on the iPod specific connection cable may be blown; if so, replace it with an equivalent fuse.
General| Brand | iSimple |
|---|---|
| Model | IS77 |
| Category | Automobile Electronics |
| Language | English |
Details connecting an iPod to the PURI interface, including cable connections and routing for audio and video playback.
Explains connecting audio sources with headphone or line outputs, including the dash mount installation procedure.
Instructions for mounting and connecting the 3.5mm dash panel audio input connector for various audio sources.
