Fault Finding
Front panel LED indicator not lit and outputs do not work;
Check that the mains inlet cable is plugged into a wall socket and that
the socket's switch is on.
Check that the fuses in the mains lead, IEC power input connector and
fuse box are intact.
Check that the connected equipment functioning correctly and are
appropriate for the units output capacity. Fuses can also age and
occasionally fail unexpectedly.
If the IEC power input fuse has blown, disconnect from the supply and replace
it with one of an identical type.
Failure to replace the fuse with the same type and
rating will invalidate the warranty and may result in an electric
shock and/or fire hazard.
If the fuse repeatedly blows or, there are two possible causes:
1. The connected equipment has a fault or is simply drawing too much
current.
2. The unit contains devices that protect against mains power surges
and high voltage spikes. In very rare cases an unusually severe event,
such as a lightning strike, can cause the unit to repeatedly blow fuses. If
this is the case and the connected equipment has been eliminated as a
cause; do not use the unit and contact your ISO-8 dealer for service.
Your MiniSub should not need servicing during normal operation. There are no
user serviceable parts inside. Do not open or attempt to repair the unit.
WARNING!
To Next Page
Loading...