To Next PageTo Next Page
Need help?Do you have a question about the Isotech MEDUSA 510 Series and is the answer not in the manual?
General| Stability | ±0.01°C |
|---|---|
| Display Resolution | 0.01°C |
| Well Depth | 150mm |
| Communication Interface | RS-232 |
| Power Supply | 50/60Hz |
Instrument warranty terms and conditions, and limitations of coverage.
Essential safety precautions for operating the Medusa apparatus.
Key guidelines and prohibitions for safe and proper use of the Medusa.
Important warning regarding the technical competence required for operation.
Procedure for removing the transit clamp before commissioning the unit.
Steps for safely unpacking and inspecting the Medusa for shipping damage.
Information on connecting the Medusa to the correct electrical power source.
Overview of the Medusa product range and its capabilities.
Methods for calibrating thermometers by comparison with a standard.
Overview of different operating modes like ITS-90 fixed points and metal block baths.
Details on using the Medusa for ITS-90 fixed point calibration procedures.
Instructions for using the Medusa as a metal block bath for sensor calibration.
Using the Medusa for calibrating infra-red temperature sensors.
Description of the Medusa's front panel controls and displays.
Explanation of the dual display temperature controller functions.
Procedure for changing the setpoint value on the temperature controller.
Details on advanced controller functions like setpoint ramp rate and instrument address.
Information on the Medusa's electronic temperature indicator and its configuration.
Guide to selecting the correct sensor input type for the temperature indicator.
Connecting and using the Medusa with a PC via the RS422 interface.
