Isotherm ve150 - User Manual

Questions and Answers

A
Adam BeckerAug 2, 2025
What to do if the Isotherm Freezer is running but not cooling?
- S
  Sara CampbellAug 2, 2025
  If your new Isotherm Freezer runs but doesn't cool, it might be due to a gas leak or insufficient gas in the system. Check the connectors and tighten them by hand until snug, then use a tool for a quarter turn, but don't overtighten as this can damage them and require replacement. If there's a gas leak (indicated by lower than normal consumption), locate it by pressurizing the system with a maximum of 5 bar of nitrogen and then seal the leak by welding.
J
Jessica MasonAug 9, 2025
Why won't my Isotherm ve150 start, even though it was working before?
- J
  Juan MillerAug 9, 2025
  If your Isotherm Freezer that previously worked won't start, the issue might stem from low voltage in the main power supply. Check the electrical connections to ensure they are secure. If the power supply isn't the issue, the compressor may need replacing.
V
Vanessa ChapmanAug 17, 2025
What to do if Isotherm ve150 runs for a few seconds then stops?
- C
  Crystal WoodAug 17, 2025
  If a new Isotherm Freezer runs for only a few seconds and then stops, the cause depends on the duration it runs. If it runs for less than 0.5 seconds, remove excess gas from the unit, considering that gas pressure may depend on the temperature. If it runs up to 2 seconds, refer to the section "L'unità lavora per qualche secondo - Unità nuova". If it operates for 3 to 5 seconds, replace the fan.
C
Charles CastanedaAug 25, 2025
How to fix a new Isotherm ve150 Freezer that won't start?
- A
  Amanda JohnsonAug 25, 2025
  If a new Isotherm Freezer doesn't start, it could be due to several reasons. The main power supply voltage might be too low, so check the cable connections. If the battery is older than 3-4 years, try recharging it, but it might need replacement. Also, check the cables for oxidation and replace them if necessary.