M) REVERB Function
1. REVERB (OFF or ON): Turns the reverb OFF or ON. Controlled
by the VALUE knob only. Turning the Reverb OFF mutes only the
input to the reverb, so the reverberated output ‘spills over’, even if
set to OFF in the next preset.
2. REVERB LEVEL (OFF to 0 dB): Sets the level.
3. REVERB DECAY (0 to 99): Sets the relative decay time of the
reverb.
4. REVERB HFDAMP (0 to 99): Set at 0, the highs will decay at the
same rate as the lower frequencies. At larger settings, the highs
will decay more rapidly than the lows, so the room will sound
‘darker’. A setting of around 20 will sound more natural, since real
rooms always absorb high frequencies faster than lows.
N) MOD SWITCH: Function
12. MOD SWITCH: (CHORUS, FLANGER, PHASER, TREMOLO, WAH, or
EXCITER): Determines the action of the MOD switch and led and also the
TAP switch. The MOD switch will turn off or on the selected effect if 2
nd
is
activated. The led will show the effect is on by blinking at the set modulation
rate. TAP will be mapped to either the delay time or the modulation rate of
the effect that is mapped to the MOD switch by the MOD SWITCH: function.
If only the MOD effect is on, TAP will be mapped to that effect. If only the
Delay is on, TAP will be mapped to Delay Time. If both are on, right after the
2nd switch is pressed, TAP will map to the delay. However, if the MOD
switch is pressed first to turn on the MOD effect, TAP will be mapped to the
MOD effect, even if Delay is ON. For example, say you are in a Preset that
has both FLANGER and DELAY turned on, and MOD SWITCH: FLANGER is
set. If you want to use TAP to set the Flanger Rate, press 2nd, then press
MOD twice to turn FLANGER off, then back on. Now TAP will be mapped to
set the FLANGER Rate. If the Flanger was initially off, press 2nd, then MOD
once to turn on the Flanger, then TAP can be used to set the Flanger Rate.
O) EXPRESSION PEDAL Function
1. EXP PDL1 (OFF, WAH FREQ, GAIN, DIRECT PAN, TREBLE,
TREBLE FREQ, TREM RATE, PHASER RATE, PHASER DEPTH,
CRS RATE 1, CHORUS MIX, FLA RATE 1, PITCH, EF DIR):
Allows you to map the EXP PEDAL input to the selected parameter.
Select OFF if you don’t want the expression pedal to be able to
change any parameters.
2. EXP MIN1 (various): Allows you to set the minimum range of the
expression pedal sweep. The units that appear with this parameter
will change to match the units of the parameter selected above in 1.
To Next Page
Loading...