Power backup that continues to keep time and the passage of days for a minimum of 48 hours in the
event of power failure. During a power outage, the control goes into a power-saving mode. It does
not monitor water usage during a power failure, but it does store the volume remaining at the time
of power failure.
• Day-of-the-Week controls.
• While in service, the display alternates between time of day, volume remaining, or days to
regeneration.
• The Flow Indicator flashes when outlet flow is detected.
• The Service Icon flashes if a regeneration cycle has been queued.
• A Regeneration can be triggered immediately by pressing the Extra Cycle button for five
seconds.
• The Parameter Display displays the current Cycle Step (BW, BD, RR, etc.) during regeneration,
and the data display counts down the time remaining for that cycle step. While the valve is
transferring to a new cycle step, the display will flash. The parameter display will identify the
destination cycle step (BW, BD, RR, etc.), and the data display will read “----.” Once the valve
reaches the cycle step, the display will stop flashing, and the data display will change to the time
remaining. During regeneration, the user can immediately force the control to advance to the
next cycle step by pressing the extra cycle button.
NOTE:
The electronic control is preset at the factory to begin regeneration at 12:00 A.M. every three
days. This ensures the right times for each step of the regeneration process. Under normal
circumstances, these settings will not need to be altered and should not be changed.
(3) The frequency and time of regeneration can be changed due to the following reasons:
• Need for the unit to regenerate at a different time of day (DO NOT regenerate any other
softener/filter at the same time as the Central Whole House Water Filtration System, since this
will interfere with the regeneration process).
• In conditions of high water usage and/or high iron levels, the unit may need to regenerate more
frequently than once every three days. The unit can be set for daily regeneration or to regenerate
every two days. DO NOT set the regeneration frequency for a longer period than 3 days, as the
filter medium can become fouled with iron, rendering the unit ineffective.
www.123filter.com | (678) 261-7611 | support@123filter.com Page 8
To Next Page
Loading...
Need help?
General
