pg. 3
Intrasonic Technology | 9525 Forest View Street | Dallas, Texas 75243|877-435-0670
Safety Instructions
Please read all instructions in its entirety before installing the I2000 system.
To reduce risk of electrical shock, the I2000 system must be installed by a qualified installer or dealer.
Do not attempt to remove or repair the I2000 system. Call a qualified installer or dealer.
Do not expose any of the I2000 system to water.
Do not install room, patio, or door within 10 feet of each other or back to back in the same wall cavity,
or on walls facing each other.
Do not mix the I2000 system with any other system. The I2000 is only compatible with other I2000
products.
Do not use staple cables or use wire splices
Use a dedicated 110V line to the master.
Do not install near light switches or near dimmer controls.
Do not install near Air conditioning ducts and metal plates for they may damage cables.
Do not exceed over 300 feet for each run of wire from the master to a room, patio, or door station.
Do not daisy chain any part of the system. All of the stations need to run back to the master.
Do not install near any heat sources.
Label all wires running back to the master.
Only one Auxiliary input can be installed for the I2000 System.
To Next Page
Loading...
General