pg. 4
Intrasonic Technology | 9525 Forest View Street | Dallas, Texas 75243|877-435-0670
Wiring
I2000M
Run a dedicated 110V line from the circuit breaker to where the I2000M master unit will be mounted.
Important Information
Not having a dedicated line could cause popping, humming, or buzzing.
I2000R, I2000P, I2000D, I2000VC, AUXWP
Run Cat5 wire from where each room, patio, door, volume control, or auxiliary unit will be mounted back to
where the master will be mounted.
Important Information
Maximum of 20 units, room, patio, door, and volume control. Any combination.
The maximum length of cable run is 300 feet per room, patio, door, volume control, and auxiliary.
Only one AUXWP per I2000M unit.
AUXWP should be located where you would like to use an external source.
Label all wires for what is a room, patio, door, auxiliary, and where they are located.
Do extra labeling if you want to name and number what unit is what. (Example: Master bedroom, kid
bedroom, garage, kitchen, ext.…)
For each end of the Cat5 wiring make sure there is sufficient slack for any wiring issues that may arise.
AM/FM Antenna
The FM antenna wire is the long black wire with a coaxial end that splits into a red and black wire. The
coaxial end will stay where the master unit will be mounted with sufficient slack. The two red and black
wires will run to the attic (or the highest point of the house) and split apart as far as possible and nail to the
studs in the attic for best reception.
The AM antenna wire is the black wire that has an antenna mount attached to it. The round metal piece will
hook up to the coaxial piece on the master before the FM antenna is connected and the 2 wires coming off
of it will clip into the black clips on the back of the master right next to the coaxial end. The antenna mount
will run up to the attic.
Important Information
To limit interference with the radio reception, keep the antenna wires away from other power wires
and sources.
To Next Page
Loading...
General