Ista MAX MIX CO2 Reactor User Manual

- The Max Mix CO2 Reactor should be used in an upright posion at all mes.
- Max Mix should be aached to the outlet of your external lter before returning to the tank.
1. First turn o the canister lter and CO2
2. Connect a CO2 hose from the CO2 tank to the CO2 inlet on the top of the Max Mix CO2 Reactor.
3. Connect the outlet hose from the canister lter to the side of the Max Mix CO2 Reactor.
4. Connect a return hose from the top center of the Max Mix CO2 Reactor to the tank (rain bar).
5. Make sure the boom of the Max Mix CO2 Reactor is securely closed.
6. Turn on the Canister lter allowing water to ow through the Max Mix CO2 Reactor into the tank.
7. Turn the Max Mix CO2 Reactor completely upside down for a few seconds to allow the built up gases (air) to
escape.
8. Return the Max Mix CO2 Reactor to an upright posion. This will allow a smooth ow of water from
Max Mix CO2 Reactor to your tank.
9. Repeat steps 6 and 7 if gases are sll present at the top of the Max Mix CO2 Reactor unl the CO2 Reactor
is full of water and no gases are present.
10. Turn on CO2 and adjust to desired bubble rate.
Note:
1. Be sure the inlet/outlet pipe and CO2 hose are securely fastened to the Max Mix CO2 Reactor
2. To assure best operaon, built-up gas (air) has to be released in the beginning of operaon
3. Do not put any lter media inside the reactor chamber. Floang ojects will aect or stop the operaon of
the impeller.
Instructions for setting up the MAX MIX CO2 Reactor
GB

Ista MAX MIX CO2 Reactor Specifications

General

Brand	Ista
Model	MAX MIX CO2 Reactor
Category	Aquariums
Language	English