4-33
CONTROLS AND INSTRUMENTS
How to Set a New Change Interval
(Odometer Reading) for Engine Oil
and Filter
1. On the MID, go to the "ENG OIL &
FILTER" screen.
2. Enter the setting change screen by
pressing and holding the MID select
knob.
3. Pressing and holding the MID select
knob sets the new change time
(distance).
NOTE
If you want to cancel the setting
procedure, press the MID select
knob momentarily. The display
goes back to the screen that was
displayed just before entering the
setting change screen.
•
4608498sec04CONTROLSANDINSTR4-334-334608498sec04CONTROLSANDINSTR4-334-33 2015/11/0213:58:402015/11/0213:58:40
To Next Page
