EasyManua.ls Logo

Isuzu FSS - Page 176

Isuzu FSS
808 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4-42
CONTROLS AND INSTRUMENTS
Engine Overheat Warning Light
WARNING
Do not remove the radiator cap or reserve tank cap when the engine coolant
is still hot. Careless removal could result in burns caused by hot vapor being
released. Burns may also be caused by boiling water released due to the high
temperature of the coolant. Perform inspection, refilling, and replacement of
coolant only when its temperature has cooled.
ADVICE
Do not shut down an overheated engine immediately. Otherwise, the engine
may seize up. Take appropriate actions for engine overheating.
Adding Engine Coolant
Refer to page 7-43
When the Engine Overheats
Refer to page 8-23
This warning light comes on (standard
model) or the message appears on the
display (model with multi-information
display (MID)) when the engine has
overheated. When the engine overheats,
the engine coolant temperature gauge
needle moves to the red zone, and the
engine overheat warning light comes on
(standard model) or the message appears
on the display (model with MID), and at the
same time a buzzer sounds. Immediately
pull off to a safe place, and check the
vehicle and take necessary actions.
CAUTION
If you continue to drive the vehicle with the engine overheat warning light on
steady (standard model) or the message appearing on the display (model with
MID), the engine may seize up.
Standard model
Model with MID
4608498sec04CONTROLSANDINSTR4-424-424608498sec04CONTROLSANDINSTR4-424-42 2015/11/0213:58:442015/11/0213:58:44