4-110
CONTROLS AND INSTRUMENTS
When Starting the Vehicle
Make sure that the low range indicator light
is on in the instrument panel.
After fully pressing the clutch pedal and
while pressing the brake pedal, place the
gearshift lever into the "1" (1st gear), "C1"
(crawler 1 gear) or "R1" (reverse 1 gear)
position. When the gearshift lever is placed
into the "R1" (reverse 1 gear) position,
the back up light comes on and a warning
buzzer sounds in a model with back up
warning.
N
C1 2 4
13
R1
Low range
CAUTION
Shift into "C" (crawler gear) or "R" (reverse gear) only when the vehicle
has come to a stop completely. Doing otherwise may cause damage to the
transmission.
Shift into the reverse gear from a forward gear or vice versa only after bringing
the vehicle to a complete stop. Doing otherwise may damage the transmission.
Fully depress the clutch pedal before operating the gearshift lever.
•
•
Model with ZF9S1110 Model Manual Transmission
V
The ZF9S1110 manual transmission requires selection of the low range or the high
range when operating the gearshift lever, unlike the 6-speed transmission.
Fully understand how to operate the gearshift lever and form a habit of operating it
correctly.
Operation Method
Low range indicator light
4608498sec04CONTROLSANDINSTR4-1104-1104608498sec04CONTROLSANDINSTR4-1104-110 2015/11/0213:59:492015/11/0213:59:49
To Next Page
