Isuzu FVM - Page 262

4-128
CONTROLS AND INSTRUMENTS
Condition and alarm type
Smoother
warning light
Warning
buzzer
Corrective action
The Smoother system has
failed.
Comes on
Continuous
beep
Stop the vehicle at a safe
place and have your vehicle
inspected at the nearest Isuzu
Dealer promptly.
Refer to "If the Smoother
System Fails" on page 4-131.
Short,
repeated
beeps
—
Smoother oil temperature is
abnormally high.
Flashes —
Stop the vehicle at a safe
place, place the gearshift lever
into the "N" position and run
the engine at idle until the
Smoother warning light goes
out.
Smoother emergency switch
is in the "ON" position.
Flashes —
Turn the Smoother emergency
switch "OFF".
HSA adjustment switch is
operated to adjust partial
clutch engagement of
Smoother.
—
One short
beep
—
An attempt is made to shift
into a gear that will cause
engine r/min to be too high
(manual mode).
—
Continuous
beep
Place the gearshift lever into
the "D" position and drive with
an appropriate gear selected.
(Automatic gearshifts will not
occur.)
An attempt is made to shift
into a gear that will cause
engine r/min to be too low
(manual mode).
—
Short,
repeated
beeps
Place the gearshift lever into
the "D" position and drive with
an appropriate gear selected.
(Automatic gearshifts will not
occur.)
Smoother Warning Light
SA
→ Refer to page 4-49
4608498sec04CONTROLSANDINSTR4-1284-1284608498sec04CONTROLSANDINSTR4-1284-128 2015/11/0213:59:542015/11/0213:59:54