4-129
CONTROLS AND INSTRUMENTS
With the Smoother system, you can select the desired degree of partial clutch
engagement from the 4 positions in both the fast and slow engagement directions from
the default (standard) setting. You need to make an adjustment in the following cases.
• If clutch engagement is too fast or too slow when you start the vehicle.
• The timing of clutch engagement does not agree with your preference.
How to Adjust Partial Clutch Engagement of Smoother
Adjustment
1. With the engine running, pull up the
parking brake lever and place the
gearshift lever into "N". Press the HSA
OFF switch to deactivate the HSA.
HSA OFF Switch → Refer to page 4-148
2. Press the "FAST" side or "SLOW"
side of the HSA adjustment switch.
If you feel the clutch slip, press the
"FAST" side. If you feel the clutch
engages abruptly, push the "SLOW"
side. Select your desired position
from among ±4 stages with the center
position as the default. This makes 9
stages in total.
3. Each time you press the adjustment
switch, a buzzer beeps once, showing
you that one step of adjustment
has completed. If you want to make
another step of adjustment, release
the switch and press it again. The
buzzer beeps again, showing you
that the next adjustment has been
completed.
N
Start
4608498sec04CONTROLSANDINSTR4-1294-1294608498sec04CONTROLSANDINSTR4-1294-129 2015/11/0213:59:542015/11/0213:59:54
To Next Page
