7-19
SERVICE AND MAINTENANCE
3. When the cab is fully lowered and the
motor sound stops, release the switch
(4) and raise the handle (1) until the
lever (2) catches.
4. When the handle (1) is securely
locked, the warning buzzer will stop.
Place the starter switch in the "ON"
position and make sure that the cab
tilt warning light (if equipped) does not
come on and that a warning message
(model with MID) is not displayed.
Cab Tilt Warning Light
V
→ Refer to page 4-59
1
2
CAUTION
After the cab is lowered to the
original position, be sure to maintain
the lever (3) in the "lower (running)"
position and lock the cab by using
the cab lock system.
•
The power cab tilt system will not operate
when the battery is dead, or the tilt motor
or pump is faulty. Even if any of these
conditions exist, you can still tilt up or lower
the cab using the following method rather
than pressing the switch. Follow the same
steps as those normally used for tilting
up or lowering the cab until the step of
operating the lever (3).
Power Cab Tilt System
V
→ Refer to page 7-15
• Insert a screwdriver into the manual
pump socket (5) and move the
screwdriver up and down to operate
the pump.
If the System Fails to Operate
3
5
4608498sec07SERVICEANDMAINTE7-197-194608498sec07SERVICEANDMAINTE7-197-19 2015/11/049:59:312015/11/049:59:31
To Next Page
