Isuzu FVM - Page 445

7-21
SERVICE AND MAINTENANCE
3. Set the lever (3) in the "UP" position.
The warning buzzer will sound at the
same time.
5. Release the cab stay bar and insert
its end into the holder on the cab.
Cab stay bar
3
4
4. Hold the switch (4) pressed until the
cab stops rising. When the cab has
tilted up fully, the warning buzzer will
stop.
WARNING
Do not go beneath the cab when it is
tilted.
•
6. Place the lever (3) in the "DOWN"
position and press the switch (4)
until the warning buzzer stops. The
warning buzzer will stop when the cab
is securely supported.
3
4
WARNING
After tilting up the cab, make sure
the cab is securely supported by the
cab stay bar.
Do not go beneath the cab when it is
tilted.
•
•
4608498sec07SERVICEANDMAINTE7-217-214608498sec07SERVICEANDMAINTE7-217-21 2015/11/049:59:322015/11/049:59:32