Isuzu N 2008 Series - Page 145

1A-142 Engine Control System (4JJ1)
13
1. Test the signal circuit between the ECM (pin
107 of E12) and the CKP sensor (pin 1 of E20)
for a short to any 5 volts reference.
2. Repair the circuit(s) as necessary.
Did you find and correct the condition?
—
Go to Step 19 Go to Step 18
14
1. Inspect for an intermittent and for poor
connections at the harness connector of the
CKP sensor (pins 1, 2 and 3 of E20).
2. Repair the connection(s) as necessary.
Did you find and correct the condition?
—
Go to Step 19 Go to Step 16
15
1. Turn OFF the ignition.
2. Disconnect the ECM harness connector.
3. Inspect for an intermittent and for poor
connections at the harness connector of the
ECM (pins 95, 107, 108 and 109 of E12).
4. Repair the connection(s) as necessary.
Did you find and correct the condition?
—
Go to Step 19 Go to Step 18
16
1. Inspect the CKP sensor and sensor rotor for
the following conditions:
• Physical damage of sensor
• Loose or improper installation of sensor
• Excessive air gap
• Foreign material passing between sensor
and sensor rotor
• Physical damage of sensor rotor
• Loose or improper installation of sensor
rotor
2. Repair or replace as necessary.
Did you find and correct the condition?
—
Go to Step 19 Go to Step 17
17
Replace the CKP sensor. Refer to CKP Sensor in
Section 1B Engine Mechanical.
Did you complete the replacement?
—
Go to Step 19 —
18
Important: Replacement ECM must be
programmed and learned.
Replace the ECM. Refer to ECM Replacement.
Did you complete the replacement?
—
Go to Step 19 —
19
1. Reconnect all previously disconnected
harness connector(s).
2. Clear the DTCs with a scan tool.
3. Turn OFF the ignition for 30 seconds.
4. Start the engine.
5. Operate the vehicle within the Conditions for
Running the DTC. You may also operate the
vehicle within the conditions that you
observed from the Freeze Frame/ Failure
Records.
Did the DTC fail this ignition?
—
Go to Step 3 Go to Step 20
20
Observe the DTC Information with a scan tool.
Are there any DTCs that you have not diagnosed?
—
Go to DTC List System OK
Step Action Value(s) Yes No
LG4JJED-WE-0871.book 142 ページ ２００８年４月４日 金曜日 午前９時６分