1A-172 Engine Control System (4JJ1)
5
1. Reconnect all previously disconnected
harness connector(s).
2. Clear the DTCs with a scan tool.
3. Turn OFF the ignition for 30 seconds.
4. Start the engine.
5. Operate the vehicle within the Conditions for
Running the DTC. You may also operate the
vehicle within the conditions that you
observed from the Failure Records.
Did the DTC fail this ignition?
—
Go to Step 3 Go to Step 6
6
Observe the DTC Information with a scan tool.
Are there any DTCs that you have not diagnosed?
—
Go to DTC List System OK
Step Action Value(s) Yes No
LG4JJED-WE-0871.book 172 ページ ２００８年４月４日 金曜日 午前９時６分
To Next Page
Loading...
