Isuzu N Series - Page 106

4-4
CONTROLS AND INSTRUMENTS
Make sure that the switches, including those for the windshield wiper, light control and
air conditioner, are in the off position.
Turn the starter switch to the "ON" position to check that the warning and indicator
lights turn on normally and the fuel level is proper.
Starting the Engine
Starting the Engine
WARNING
Do not keep the starter switch in
the "START" position for more than
about 10 seconds. Operating the
starter for too long might cause
battery failure or might result in
overheating and even a fire.
•
Starter Switch → Refer to page 4-34
ADVICE
Using a key sticking with dirt or dust, etc. may possibly damage the starter
switch. Make sure to wipe off any dirt or dust, etc. before inserting the key.
•
LOCK
ACC
ON
START
4612812sec04CONTROLSANDINSTR4-44-44612812sec04CONTROLSANDINSTR4-44-4 2016/04/1416:34:592016/04/1416:34:59