8-18
IN CASE OF EMERGENCY
2. Operate the priming pump on the
chassis side up and down more than
20 times until the fuel from the air
bleed of the engine-side fuel filter no
longer contains air bubbles.
3. Fully retighten the air bleed plug
and wipe off any fuel that may have
adhered to the plug or surrounding
area.
After You Have Bled Air from the
Fuel System
1. Operate the priming pump up and
down more than 10 times to feed air
in the fuel system to the fuel supply
pump.
2. Without depressing the accelerator
pedal, turn the starter switch and start
the engine.
3. After the engine has started, allow it
to idle for 5 seconds.
4. Fully depress the accelerator pedal
and increase the engine r/min to the
maximum speed, then keep it for
10 seconds. (Repeat this operation
several times.)
Engine-side Fuel Filter
1. Place a container beneath the air
bleed plug of the engine-side fuel filter
to receive the fuel, and remove the
rubber cap from the air bleed plug.
Connect a plastic hose to the air bleed
plug to prevent the fuel from spilling.
Fully loosen the air bleed plug.
4612812sec08INCASEOFEMERGEN8-188-184612812sec08INCASEOFEMERGEN8-188-18 2016/04/1416:49:052016/04/1416:49:05
To Next Page
Loading...
