8-19
IN CASE OF EMERGENCY
Before Starting the Engine
1. Place a container beneath the air
bleed plug to receive fuel, and then
fully loosen the plug.
2. Operate the priming pump up and
down about 20 times until the fuel
from the air bleed plug no longer
contains air bubbles.
3. Fully retighten the plug and wipe off
any fuel that may have adhered to the
plug or surrounding area.
4. Operate the priming pump up and
down about 10 times to feed air in the
fuel system to the fuel supply pump.
5. Turn the starter switch to start the
engine.
ADVICE
Insufficient air bleeding can result
in faulty engine operation. Be
sure, therefore, to always carry out
the procedure described in "After
Starting the Engine".
•
Priming pump
Air breed plug
After Starting the Engine
1. Without depressing the accelerator
pedal, turn the starter switch and start
the engine.
2. After the engine has started, allow it
to idle for about 5 seconds.
3. Fully depress the accelerator pedal
and increase the engine r/min to the
maximum speed.
(Repeat this operation several times.)
Bleeding the Fuel System (4JJ1 Engine Model with
Chassis-side Fuel Filter (Type 2)) (4HK1/4JB1-TC/4HG1-T
Engine Models)
4612812sec08INCASEOFEMERGEN8-198-194612812sec08INCASEOFEMERGEN8-198-19 2016/04/1416:49:052016/04/1416:49:05
To Next Page
Loading...
