8-20
IN CASE OF EMERGENCY
Before Starting the Engine
1. Operate the priming pump up
and down to perform air bleeding.
Repeatedly operate the priming pump
up and down until its operational force
becomes strong.
2. Turn the starter switch to start the
engine. Without depressing the
accelerator pedal, turn the starter
switch and start the engine.
Starting the Engine
→ Refer to page 4-4
3. If the engine could not be started, try
again from step 1.
ADVICE
Insufficient air bleeding can result
in faulty engine operation. Be
sure, therefore, to always carry out
the procedure described in "After
Starting the Engine".
•
After Starting the Engine
1. After starting the engine, remain in
idle for 1 minute. If the engine stalls
when in idle, perform step 3 and then
start the engine again.
2. Fully depress the accelerator pedal to
increase the engine speed. When the
engine speed reaches its maximum,
immediately release the accelerator
pedal and return to idle. Repeat this
operation three times.
Bleeding the Fuel System (4JH1 Engine Model)
4612812sec08INCASEOFEMERGEN8-208-204612812sec08INCASEOFEMERGEN8-208-20 2016/04/1416:49:052016/04/1416:49:05
To Next Page
Loading...
