Why does my Italtecnica Brio 2000-M Controller pump start and stop frequently?
If your Italtecnica Controller pump starts and stops frequently, it's likely due to leaks in the system. Inspect the system thoroughly to identify and fix any leaks.
How to troubleshoot an Italtecnica Brio 2000-M when the pump does not deliver any liquid?
If the Italtecnica Controller pump isn't delivering liquid, consider these possibilities: * The Fluomac might be installed incorrectly; double-check its installation and correct it if needed. * The priming process might not have been done properly; try pressing and holding the RESET button until the flow becomes regular. * The suction hose may not be fully submerged; ensure it is properly immersed in the liquid.
What to do if my Italtecnica Brio 2000-M pump is running and does not stop?
If your Italtecnica Controller pump runs continuously and doesn't stop, make sure to: * Check the plumbing system. * Remove any valves from the system, as significant leaks or a check valve installed before or after the Brio 2000 device could be the cause.
Why doesn't my Italtecnica Brio 2000-M pump reach the desired pressure?
If the Italtecnica Controller pump isn't reaching the desired pressure, check the system for leaks and remove any clogs from the hose or suction filters. Also, the foot valve might be blocked and needs replacement.
What to do if Italtecnica Controller stops the pump even in presence of water?
If the Italtecnica Controller device stops the pump from running even when water is present, the pressure might be set too high. Try decreasing the pressure until the problem is resolved, and consider contacting a professional installer. Also, the pump’s thermal protection may be preventing it from running, so check the pump.
Details on connecting the device to the plumbing system, including orientation and pressure considerations.
Instructions for electrical connections, including cable types and power protection.
General| Frequency | 50/60 Hz |
|---|---|
| Maximum current | 16 A |
| Starting pressure | 1.5 bar |
| Maximum pressure | 10 bar |
| Maximum temperature | 60°C |
| Protection degree | IP65 |
| Timer Range | Not applicable |
| Power supply | 230V |
| Type | Pressure switch |
To Next Page
