To Next PageTo Next Page
Need help?Do you have a question about the Italtecnica Fluomac and is the answer not in the manual?
Lists and identifies the functional parts of the Fluomac device, including indicators, buttons, and connections.
Explains the Fluomac's function in automating pump start/stop based on pressure and preventing dry operation.
Details essential safety rules to prevent shocks and fire risks, including unplugging and suitable wiring.
Advises using an automatic RCD with 30mA protection for swimming pools, ponds, and fountains.
Warns that pipes are under pressure when the pump stops and recommends opening a tap before work.
Instructs to install Fluomac between pump and outlet, noting arrow direction and water tightness.
Advises on pressure reducers for pumps >10 bar and electrical wiring for high power/temperature.
Emphasizes the need for a suction line with an antibackflow foot valve if the pump is below water level.
Outlines the steps for filling the suction pipe and pump, then starting the pump via Fluomac.
Explains how to recognize dry stops and reset the system after checking water presence.
States the warranty is valid for 24 months and requires no tampering and adherence to instructions.
Addresses causes and solutions for the pump cycling on/off continuously or failing to stop.
Covers issues like the pump not restarting or dry stops, with troubleshooting steps.
Lists key technical data including power, current, pressure ranges, temperature, and connections.
General| Current Rating | 10A |
|---|---|
| IP Rating | IP65 |
| Terminal Type | Screw |
| Voltage Rating | 250V |
| Material | Plastic |
| Mounting Type | In-line |
