What to do if Itamar Medical Equipment fails to establish a connection?
If the Application cannot find an active Itamar Medical device, and there is no blinking on the device cover, ensure the battery is correctly placed and press SCAN AGAIN. If it is blinking, move the device closer to your phone and press SCAN AGAIN. If the RED blinking continues after pressing SCAN AGAIN, the device may be faulty and needs to be returned.
What to do if Itamar Medical Equipment has a data transmission failure?
To fix a data transmission failure with your Itamar Medical device, ensure the phone and the device are close to each other until all stored data has been sent to the Application.
What to do if Itamar Medical Equipment shows 'Not enough storage'?
To address the 'Not enough storage' issue with the Itamar Medical Application, you need to free up the requested amount of storage on your mobile phone.
What to do if Itamar Medical Equipment shows a data completeness failure?
To resolve a 'Data completeness failure' with Itamar Medical equipment, keep the APP running and close to the device until a message appears confirming that all data has been successfully transmitted.
What to do if Itamar Medical Equipment sees more than one active device?
If the Application sees more than one active Itamar Medical device, ensure other devices in the room are turned OFF until your Application successfully establishes communication with your device.
General| Connectivity | Bluetooth |
|---|---|
| Disposable | Yes |
| Brand | Itamar Medical |
| Model | WatchPAT ONE |
| Regulatory Approvals | FDA Cleared, CE Marked |
| Technology | Peripheral Arterial Tone (PAT) |
| Sensors | Actigraphy |
| Usage | Home Sleep Apnea Testing |
| Battery Life | Single-use |
| Type | Portable Diagnostic Device |
Covers environment, app installation, setup, and patient preparation for the test.
Instructions for starting, monitoring, and ending the sleep test.
Details battery insertion, device mounting, sensor attachment, and mobile app usage.
To Next Page
