iTOUCH Playzoom Walkie Talkies User Manual

WALKIE TALKIES
BELT CLIP ATTACHMENT
ON / OFF BUTTON
RECEIVE / TRANSMIT
HOW TO CHANGE CHANNELS
1. To remove the belt clip,
press the tab at the top of
the clip and slide upward.
2. To reattach, slide clip
piece down with the clip
facing inward until you
hear a click.
Press and hold down the power button (right of
LCD screen) for 3 seconds to power the device on
or off, a beep will indicate operation.
To transmit, press and hold the TALK button while
talking into the device at a close range. Release
the button to finish talking - when the button is
released your walkie-talkie can receive transmissions.
Note: Walkie-talkies must be set to the same
channel and CTCSS code.
Release the TALK button when you’re finished
talking to receive a response.
• Press the MENU button once; the current channel
number will flash on the LCD screen.
• Press up & down buttons to change channel.
• Press the TALK button to confirm and return to
Standby mode.
Note: If no button is pressed, the device will return
to Standby Mode.
1. Press down on the back
panel of the unit and slide
the battery cover off (you
may need to remove the
belt clip for easier access).
2. Insert 4AAA Batteries
(not included).
3. Replace the cover.
BATTERY INSTALLATION

iTOUCH Playzoom Walkie Talkies Specifications

General

Brand	iTOUCH
Model	Playzoom Walkie Talkies
Category	Toy
Language	English

Summary

Belt Clip Attachment

Battery Installation

Power and Operation

On/Off Button

Press and hold the power button for 3 seconds to turn the device on or off. A beep indicates operation.

Receive/Transmit

Press and hold TALK to transmit; release to receive. Devices must be on the same channel and CTCSS code.

Change Channels

Press MENU, use UP/DOWN to select channel, press TALK to confirm. Returns to Standby if no button is pressed.

Advanced Settings

CTCSS (Continuous Tone-Coded Squelch System)

Explains CTCSS for private communication, allowing channel selection and code adjustment via menu.

Change CTCSS Code

Instructions to change the CTCSS code using the MENU, UP/DOWN buttons, and confirming with TALK.

VOX Selection

Enables voice-activated transmission without pressing TALK. Adjust sensitivity via MENU, UP/DOWN, and TALK buttons.