The cleaner can be controlled by the infrared remote controller. As shown in
the diagram above, there are three mode keys: Spot, Clean and Max, which
will activate the respective three working modes. By using the directional keys,
the remote can control the cleaners’ movement. The “P” key is used to power
the unit on/off. If you press the P key, the indicator light on the unit will turn off,
and the Cleaner will enter Sleep mode, which will save energy while in its non-
operating state. If you press the P key again, indicator light on the unit will turn
on, and the Cleaner will enter the Standby mode, while waiting for the next
command.
The Intelligent cleaner is user-friendly with very little maintenance required
after use. To ensure optimal performance please observe the following
procedures:
To Next Page
Loading...
