Note:
• You must make the time and alarm time adjustments while the display is
flashing. The display will stop flashing after approximately 10 seconds if
adjustments are not made.
Radio
General operations
Pre-set station memory
Sleep mode
When the radio is on, press “SNOOZE / SLEEP / DIM” button (1) to enter sleep
mode. “OFF” will be displayed. Press “SNOOZE / SLEEP / DIM” button (1)
repeatedly for the duration of the “SLEEP” time. The range of “SLEEP” time is
90 minutes to 10 minutes, as displayed on the screen.
NAP
Set the desired NAP time and the radio will turn on automatically after the
preset time.
1. When the radio is off, press and hold “ON / OFF / NAP” button (2) for
approximately 4 seconds and the display and FM indicator (D) will flash.
-5-
-6-
6. Follow the same instructions for alarm 2 with “ALARM 2 / VOL +” button
(8).
1. Press the “ON/OFF/NAP” button (2) to turn FM radio or AM radio on.
2. For manual tuning, press “HOUR / TUNING –“button (5) or “MIN / TUNING +
“button (9) for FM increments of 0.1mHz (AM increments of 0.009MHZ).
3. For automatic tuning, press and hold down the “HOUR / TUNING –“button
(5) or “MIN / TUNING +“button (9) for approximately 3 seconds. Depress
the button and the radio will start to scan for the next available station.
4. Press “ALARM 1 / VOL –“button (4) or “ALARM 2 / VOL +“button (8) to adjust
volume level. The display changes to show the volume level indication
(00 to 14) during the volume adjustments, then changes back to the
radio station frequency and then the current time.
5. Press “HOUR / TUNING –“button (5) or “MIN / TUNING +“button (9) to show
the radio station frequency.
1. The radio can store up to 20 FM stations and 20 AM stations.
2. To store a station in memory, tune to the desired radio station. Press and
hold down “TIME/PRESET” button (6) for approximately 3 seconds and “P01”
on the display will flash. Press the “P+” button (7) or “P-“ button (3) to the
desired station memory (P01 to P20). Press “TIME/PRESET” button (6) once
to confirm.
3. Repeat the above steps for up to 20 stations.
4. To recall the station, press “P+” button (7) or “P-“ button (3) until desired
station is reached.
snooze mode. Alarm will sound again after 5 minutes. Alarm buzzer does
not cut the radio sound. If alarm waken up by radio, volume control for
radio is not available.
When the radio is off and the current time is showing, press “SNOOZE / SLEEP
/ DIM” button (1) to select the brightness of the display between high or low.
Dimmer
3. Press “ON / OFF / NAP” button (2) to confirm.
2. Press “P+” button (7) or “P-“ button (3) to set the desired nap time (45, 60,
90 or 120 mins)
To Next Page
Loading...