!
W
arning:
Driving operation
no
tic
e
In order to ensure your safety, please practice in the open place for the first time, master
t
h
e
essentials after riding on the road, and please consciously obey the traffic rules, to ride on
the
non-motorized
road, do not lend to people who can not operate the three
wheeler
.
The role of the manipulation
p
art
The structure of the manipulation part is shown on page 04, and the functions of each part in
the
figure are as
f
ollo
ws:
1. The left brake handle is the rear brake and brake cut off the power control switch handle, when
hold
the
brake handle, the rear brake stop, the brake light on, and the controller output to the
motor
voltage
down to zero, the motor stop working, make the rear wheel brake double insurance.
2. Lighting switch (headlight switch and variable lighting switch), when driving at night, first dial
t
he
lighting switch to the first gear position. At this time, the night taillights on; then dial the he
adlight
switch
to the second gear, the far and near light can
w
ork.
3. The high and low beam switch can convert the strength and distance of the light beam with
high
light; the position and the beam irradiation down to the near light, weak light. Note: For safety
reasons, when driving at night, the current light switch should be pushed to the position .
4. Turn signal switch in the turn left or right and change the lane, the signal light switch. When
di
a
li
ng
to R
(right), the front and rear turn lights on the right side flash to signal a right turn. When dialing to L (left), the
front and rear turn lights of the left side flash to signal a left turn. Close to the
middle
position, press
the switch inward to
r
e
turn.
To Next Page
Loading...