Safety Precautions
• Read all safety precautions listed at the beginning of this manual.
• It is recommended to use a dedicated circuit for this ice maker.
• Do not use receptacles that can be turned o by a switch or pull chain.
• Do not connect or disconnect the electric plug with wet hands.
• Never clean the ice maker with flammable liquids. The fumes can create a fire hazard or
explosion risk.
• Do not store gasoline or other flammable vapors/liquids in the vicinity of this or any
other appliance.
• Do not attempt to repair or replace any part of the ice maker unless specifically
recommended by the manufacturer. All other servicing should be referred to a
qualified technician.
• Never install or operate the unit in an enclosed area, such as a closed cabinet. Choose a
well- ventilated area with temperatures between 50°F and 100°F. The unit MUST be
installed in an area protected from the elements, e.g., wind, rain, water spray or drips.
• Do not place the unit next to ovens, grills or other sources of high heat.
• The ice maker must be installed with the electrical in accordance with state and
local code.
• Do not bend or pinch the power supply cord.
• The unit must be on a level surface in order to work properly.
• Check for leaks after water is added.
• Never allow children to operate or play with the ice maker.
• When using the ice maker for the first time (or after a period of inactivity), it is
recommended to discard the first two batches of ice to ensure machine is
thoroughly clean.
• Never tilt the ice maker more than 45 degrees.
• If the ice maker has not been used for a long time, clean thoroughly before use. Follow
instructions provided for cleaning and sanitizing.
• Do not leave any solution inside the unit after cleaning.
• Make sure the plug is accessible after installation.
• Do not use this appliance for anything other than its intended purpose.
• Do not touch the evaporator by hand when the unit is operating.
• Use only drinking water with this product.
• If the supply cord is damaged, it must be replaced by the manufacturer, a service agent
or similarly qualified person in order to avoid a hazard.
• The ice maker is equipped with a 3-prong grounding plug. To minimize possible shock
hazard, the cord must be plugged into a mating 3-pronged and grounding-type wall
receptacle. Do not cut or remove the ground prong. If a mating wall receptacle is not
available, it is the responsibility of the customer to have a properly grounded 3-prong
wall receptacle installed by a certified electrician.
2
To Next Page
Loading...
