Getting started
• First open the drawer with the key in order to install the batteries. Batteries are located inside the safe.
• To open the safe, insert the key and turn clockwise until the drawer automatically opens.
• Install the batteries (see the section on installing the batteries.)
Note: The key can also be used in case you lose or forget your security code, or if the batteries run low. If
you lose your key you can purchase a replacement key by contacting Ivation Customer Service at
info@myivation.com or 866-849-3049. You must use the serial number for reference.
Installing the Batteries
1. Remove the drawer from the safe by taking it off the track. This can be
done by pulling down on the pressure point on either side of the drawer’s
track and pulling the drawer out of place.
2. Push the battery cover locking tab with a screwdriver to release the cover.
3. Once the battery compartment is open, install 4 AA alkaline batteries
(as shown.)
4. Click cover back into place by inserting the rear tabs into the appropriate slots.
5. Do not mix old and new batteries.
6. Do not mix alkaline, standard, and rechargeable batteries.
Note: If the batteries are low the combination buttons will flash red when they
are pushed. Please replace batteries as soon as possible if lights flash red.
Programming Your Combination
• For security purposes, you must program your own combination before opening the safe. The default
sequence is: Left-Center-Right. Press the buttons in this order.
• Record your combination in this user guide, or in a secure location.
• Make sure the sound on the safe is turned on.
1. To program, press and hold the RESET BUTTON (Figure 3), located inside the safe, for 3 seconds.
2. Once you press the RESET BUTTON you will hear two beeps (when sound is turned on), and all 3
buttons will flash green twice. You will have 5 seconds to begin entering your combination.
Note: If you do not begin in 5 seconds you will need to begin this process again
To Next Page
Loading...