Selecting a Location for Your Safe
This safe was designed to be mounted to a shelf. Failure to do so will compromise the safety and security
of the safe. Install the safe in a secure, isolated, and dry area.
THE SAFE SHOULD ALWAYS BE KEPT OUT OF REACH OF CHILDREN.
NOTE ON LOCKING THE SAFE: The safe needs to be in an upright position. This must be done for the
locking mechanism to work properly. Failure to mount the safe in the correct position will compromise the
safety and security of the safe.
Mounting the Safe
1. In order to access the pre-drilled holes, you will need to remove the drawer from the safe by taking it
off the track. This can be done by pulling down on the pressure point on either side of the drawer’s
track and pulling the drawer out of place.
2. Place the safe in the desired location on a shelf, and mark the location of the pre-drilled mounting holes
on the bottom of the safe with a pencil.
3. Remove the safe from the shelf where you will be securing it.
4. Drill pilot holes for the screws – make sure they are 3/16” in diameter.
5. Place the safe back on the shelf, and line up the pre-drilled holes at the bottom of the safe with the
pilot holes you have just drilled.
6. Using the provided screws and washers, secure safe to the shelf.
7. Place the drawer inside the safe.
IMPORTANT REMINDERS
• Keep keys and your combination sequence in a secure place away from children.
• Do not place keys inside of safe.
• Keep the safe’s serial number and combination separate from your safe.
Specifications:
Dimensions: 12.2" x 10" x 4.5"
Weight: 17 lbs.
Customer Service
info@myivation.com
866-849-3049
To Previous Page
Loading...