Air Purging:
With normal use, air can get trapped in the washer’s hose. We recommend the following steps to purge the
air out of the system and achieve maximum washing pressure:
1. Turn Tank Cover (2) counterclockwise to remove.
2. Power up your Smart Washer.
3. Point the Spray Gun (15) into the water tank and squeeze the lever until the water stream steadies.
4. Replace Tank Cover (2) clockwise by turning clockwise.
It is also advisable to repeat the above steps after each water tank refilling.
Shuto & Storage:
1. Toggle the Power Switch (5) to the “O” position.
2. Disconnect that Spray Gun (15) from the Hose (18).
3. Pull Spray Gun (15) trigger to remove any remaining water.
4. Turn unit back on and run for approximately 30 seconds.
5. Toggle the Power Switch (5) to the “O” position.
6. Disconnect Hose (18) from unit and drain any remaining water.
7. Spill any remaining water from Water Tank (1).
8. Place all loose parts in Mesh Storage Compartment (7).
9. Store your Portable Smart Washer indoors above 32°F.
Storing in Freezing Conditions:
If unit must be stored in temperatures below 32°F, you can prevent freezing and reduce mineral deposits
by using a pump winterizer/protector or a non-toxic RV anti-freeze.
Warning: Use only RV anti-freeze. All other anti-freeze products are corrosive and can damage pump.
1. Pour approximately 3 liters (1/2 gallon) of RV anti-freeze into Water Tank (1).
2. Connect Hose (18), Spray Gun (15) and Power Cord (9).
3. Turn Tank Cover (2) counterclockwise to remove.
4. Point Spray Gun (15) into tank and squeeze trigger for approximately 30 seconds or until anti-freeze
stream steadies.
5. Toggle the Power Switch (5) to the “O” position.
6. Pull trigger to release pressure.
7. Disconnect Hose (18), Spray Gun (15) and Power Cord (9).
6. Place all loose parts in Mesh Storage Compartment (7).
6
To Next Page
Loading...
Need help?
General
