Using After Storing with Anti-Freeze:
1. Turn Tank Cover (2) counterclockwise to remove.
2. Spill anti-freeze from Water Tank (1).
3. Replace Tank Cover (2) clockwise by turning clockwise.
4. Connect Hose (18), Spray Gun (15) and Power Cord (9).
5. Fill tank with clean water and run unit until tank is empty.
6. Fill with clean water once more, as use as usual.
Care & Maintenance
Unclogging Spray Gun:
Clogging causes excessive water pressure, which may cause the portable washer to surge. Follow these
steps to restore your washer to proper function:
1. Toggle the Power Switch (5) to the “O” position and unplug the unit.
2. Pull the Spray Gun (15) trigger to release any water pressure.
3. Disconnect Spray Gun (15) from Hose (18).
4. Clean the Spray Gun (15) using a nozzle cleaning tool.
5. Use clean water or compressed air to flush any remaining dirt, etc.
6. Connect Spray Gun (15) to Hose (18) and test unit.
7. If water pressure is still too high, repeat steps 1 and 2.
Replacing Fuse:
In the event that your Portable Smart Washer has surged, replace the fuse by following these steps:
1. Unscrew end of Power Cord (9) adaptor.
2. Remove and discard old fuse.
3. Replace with new fuse.
4. Screw end of Power Cord (9) adaptor back on.
Caring for the Internal Battery:
- Charge battery fully before first use.
- To ensure maximum battery life, charge battery fully after each use.
- Even when not in use, it is recommended to charge the battery at least once every three months.
- To prevent electric shock, use an insulated glove when handling or maintaining.
- If battery shows defect, contact manufacturer or distributor. Do not disassemble.
- Do not use any organic solvents to clean battery.
7
To Next Page
Loading...
Need help?
General
