Need help?Do you have a question about the IXL Tastic Ovation 31511 and is the answer not in the manual?
Built-in thermal switch automatically cools the unit when overheated.
PTCR cuts power at 80°C; reset by power cycling.
Appliance must not be supplied via external switching device or timer.
Key safety instructions for operation and installation.
Explains the 800W tungsten halogen heat lamp for radiant heat.
Describes the 3 x Frosted LED globes for diffused lighting.
Details the centrifugal fan and airflow needs for steam removal.
Step-by-step guide to safely remove the glass shield.
Instructions on how to detach the old heat lamp.
Guidance on installing a replacement heat lamp correctly.
Step-by-step guide for replacing the LED globes.
Specifies genuine IXL infra red halogen heat lamps.
Identifies unique IXL frosted LED globes for replacement.
Recommendations for cleaning the unit and maintaining performance.
Contact details for product service and support.
Answers common questions about heating, noise, and operation.
Addresses queries regarding installation and switch mechanisms.
Discusses fan performance and ducting options.
Details warranty coverage, duration, and conditions.
Lists exclusions and conditions that void the warranty.
Step-by-step guide on how to initiate a warranty claim.
Information on how personal data is handled.
Instructions and links for registering warranty online for Australia and NZ.
Provides contact details for comments, questions, or warranty matters.
The IXL Tastic Ovation is a multi-functional bathroom appliance designed to provide heating, lighting, and ventilation. It integrates an 800W tungsten halogen heat lamp, three 7W GU10 frosted LED globes, and a 180mm exhaust fan.
The primary function of the Tastic Ovation is to offer a comprehensive bathroom climate and lighting solution. The 800W tungsten halogen heat lamp provides instantaneous radiant heat, specifically designed to warm the body directly rather than the entire room. This targeted heating approach is efficient, concentrating warmth for maximum effectiveness, especially when standing directly under the lamp. The heat lamp is half-coated with a white reflector to optimize heat dispersion.
For lighting, the appliance features three frosted LED globes that deliver diffused light, creating a soothing ambiance in the bathroom without compromising on lighting quality. An intelligent control system ensures the longevity of the LED globes: they will not operate while the heat lamp is switched on. If the heat lamp is activated while the LEDs are on, the LEDs will automatically turn off and then turn back on once the heat lamp is deactivated.
The ventilation component consists of a high-performance centrifugal fan designed to extract steam and moisture from the bathroom and vent it directly outside. Effective ventilation relies on adequate airflow into the bathroom, which can be achieved through open windows, vents, or gaps under doors. The ideal airflow path should pass over the steam source. For bathrooms with high ceilings, larger than average dimensions, or open showers, additional ventilation may be required. The fan's performance is influenced by factors such as cross-ventilation, room air flow, and climate. In cooler climates, increased moisture and condensation may be observed during hot showers, suggesting a need for improved natural ventilation or an additional exhaust fan.
The Tastic Ovation also incorporates safety features to prevent overheating. If the heat lamp is operating and the fan is off, a built-in thermal switch will automatically activate the fan when the internal temperature reaches 65°C to cool the unit. Once the temperature drops, the fan will switch off. Furthermore, an over-temperature switch (PTCR) will cut off power to the unit if the temperature reaches 80°C. This PTCR can be reset by turning off power at the isolating switch and allowing the unit to cool for 10-15 minutes. If the PTCR activates, it indicates abnormal operation, and the service center should be contacted. To avoid inadvertent resetting of the thermal cut-out, the appliance should not be supplied through an external switching device like a timer or connected to a circuit that is regularly switched on and off by the utility.
The Tastic Ovation is designed for horizontal installation in the ceiling. It is crucial that the appliance is not covered with insulating material or similar materials to prevent overheating. The lowest point of the appliance must be at least 2.2 meters from the floor, and it should not be mounted immediately below a socket outlet. Direct eye contact with the heat lamps when in use should be avoided, as Tastic products are not tanning lamps. The appliance should always be operated with the fascia or glass panels in position.
The wall switch, supplied with the unit, controls the various functions. The wall switch mechanisms can be rotated by a qualified electrical tradesperson, and alternative switch mechanisms can be used by an authorized installer.
For optimal performance, the Tastic Ovation is manufactured to suit bathroom ceiling heights from 2.2m. While the unit is designed to remove moisture and steam, factors like room size, ceiling height, and shower type can influence its effectiveness. For larger or high-ceiling bathrooms, additional ventilation may be beneficial.
Regular maintenance is essential to ensure the quality, functionality, and longevity of the Tastic Ovation. It is recommended that the appliance body, fascia, and lamps be checked and cleaned every two years.
To clean the fascia and air inlet, use a damp cloth with liquid glass cleaner. Always ensure the unit is turned off and all lamps have cooled before cleaning.
The Tastic Ovation is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless supervised or instructed by a responsible person. Young children should be supervised to ensure they do not play with the appliance. To prevent overheating, no object should be placed within 1 meter of the heat lamps. Curtains or combustible materials may ignite if in contact or close proximity with the heater. Regulations concerning the discharge of air must be fulfilled.
General| Type | Bathroom Heater |
|---|---|
| Heating Method | Heat Lamps |
| Bathroom Heater | Yes |
| Exhaust Fan | Yes |
| Grille Colour | White |
| Control Type | Wall Switch |
| Installation | Ceiling |
| Heat Lamps | 2 |
To Next Page
