Izip E3 Vibe User Manual

Quick start guide
IZIP E3 Vibe
IMPORTANT: The IZIP owner’s manual included
with your bike contains most of the important safety
and usage information about this bike, which is not
included in this quick start guide. Be sure to read the
IZIP owner’s manual before operating or working on
the bike for the fi rst time.
1. Charging the battery
You should charge your bike’s battery fully before you
ride the bike for the fi rst time. An empty battery will take
about 4–6 hours to fully charge.
1. Plug the charger into the battery’s charging port (1).
2. Plug the charger into a wall outlet.
The charger will begin to charge the battery. The light
on the charger indicates charging status:
Blue light: The charger is powered on and standing
by, but is not charging a battery.
Red light: The charger is charging the battery.
Green light: Charging is complete.
The E3 Vibe’s lithium-ion battery does not have a “memory”. This means it
can be charged at any time, and charged partially, without causing damage or
affecting performance.
The “Battery Care” section of your owner’s manual contains information on
how to properly care for your battery. A battery that is not properly cared for will
quickly degrade .
2. Getting ready to ride
Connect the battery
Remove the protective rubber cap from the battery terminal (2) on one side
of the rack. Slide the battery into the rack, as shown . The battery decal should
face outward.
Push the battery down, then lock the battery in place with the key (3). Do not
ride with the battery unlocked.
The battery can be connected to either side of the rack. If you have two bat-
teries, both can be mounted at once to double your range.
Turn on the bicycle
First, set the battery selector switch (4). The battery selector switch is on the rear of the rack, labeled ON/ON. Flip the
switch toward the installed battery (left or right). If you have two batteries installed, you can change between them at any
time using this switch.
After you have selected the battery, press the ON/OFF button (5) on the throttle. The battery gauge lights (6) will illumi-
nate, and the bike is ready to ride.
2
1
4
3
1
4
Version 11/18/13

Izip E3 Vibe Specifications

General

Brand	Izip
Model	E3 Vibe
Category	Scooter
Language	English

Summary

Charging the Battery

Battery Charging Status Indicators

Details the charger's indicator lights (blue, red, green) for battery charging status.

Lithium-ion Battery Care

Notes that the battery has no memory and provides advice on proper care to prevent degradation.

Getting Ready to Ride

Connecting the Battery

Instructions on how to attach and secure the battery to the bike's rack.

Powering On the Bicycle

Steps for selecting the battery and turning on the bicycle using the throttle.

Riding the Bicycle

Understanding the Battery Gauge

Explains the throttle lights indicating remaining battery power levels: full, half, and empty.

Riding Assist Modes

Describes the Pedal Assist (PAS) and Twist and Go (TAG) power modes for riding.