Important notes
Do not discard any packaging until you have checked the parts against the list below.
Please take a few minutes to read through the assembly instructions. Unpack your cot bed carefully
onto a soft level surface such as a carpeted floor. Familiarise yourself with the parts by comparing
them with the checklist provided below.
The recommended mattress size for this cot bed is 140 x 70 cm.
The Skyline cot bed is designed to be used from birth to approximately 4 years.
The base can be fixed in 3 positions. The lowest position being the safest (refer to safety notes).
The cot can be converted into a toddler size bed (approximately from 18 months to 4 years of age).
Please be careful when moving cot-bed ends.
The bottom section may separate from the top if not held in place.
There is a line engraved on each of the cot bed sides. These should face the inside of the cot bed.
These lines determine the maximum height of the mattress when the base is in the highest position.
(refer to safety notes).
Please make sure that all assembly fittings shall always be correctly tightened and checked regularly.
This cotbed is designed to BSEN716-1 2008 Safety Standards for cots
This bed is designed to BS 8509 : 2008 Safety Standards for Childrens Beds
Parts checklist
Ref
4
4
8
Bed base fixing
C
B
A
D
Barrel Bolt
Bolt (35mm)
QtyDescription
Part
Barrel nut & Grub screw
8
1
E
1
Allen Key
F
8
4
Dia 8x40Dowel
Capping Bolts
Bolt ( 50mm)
G
H
8
To Next Page
Loading...
