The Tranquillity cot bed is designed to be used from birth to approximately 4 years.
The base can be fixed in 3 positions. The lowest position being the safest. (refer to safety notes).
This cot can be converted into a toddler size bed (approximately from 18 months to 4 years of age).
Please be careful when moving the cotbed ends!
The bottom section may separate from the top if not held in place.
Do not discard any packaging until you have checked the parts against the list below.
Please take a few minutes to read through the assembly instructions.
Unpack your cot bed carefully onto a soft level surface such as a carpeted floor.
Familiarise yourself with the parts by comparing them with the checklist below.
The recommended mattress size for this cot bed is 1400 x 700 x 100 mm.
The base can be fixed in 3 positions.
The toddler sized bed conforms to BS8509 : 2008 + A1:2011 - Safety Standards for children beds.
Ref Part Description Qty
A Barrel nut 8
B Barrel Bolt 8
C Bolt(30mm) 4
D Bolt(40mm) 4
E Bolt(60mm) 8
F Allen Key 1
G Dowel(30mm) 4
H Dowel(40mm) 4
I Bolt for bed base 4
J Foot nail 4
1
These lines determine the maximum height of the mattress when the base is in the highest position.
There is a line engraved on each of the side rails(see diagram on page 3).
The engraved line should face the inside of the cot bed.
This cot conforms to BS EN716-1 : 2008 + A1:2013 - Safety Standards for cots.
To Next Page
Loading...
